Braun 7 Seres - Page 22

22
Tips for the perfect dry shave
For best shaving results, Braun recommends you to follow 3 simple steps:
1. Always shave before washing your face.
2. At all times, hold the shaver at right angles (90°) to your skin.
3. Stretch your skin and shave against the direction of your beard growth.
Shaving with the cord
If the rechargeable batteries are discharged, you may also shave by connecting the
shaver to an electrical outlet via the special cord set.
Cleaning
Regular cleaning ensures better shaving performance. Rinsing the shaver head under
running water after each shave is an easy and fast way to keep it clean:
• Switch the shaver on (cordless) and rinse the shaver head under hot running
water until all residues have been removed. You may use liquid soap without
abrasive substances. Rinse off all foam and let the shaver run for a few more
seconds.
• Next, switch off the shaver, press the release button (2) to remove the Foil & Cutter
cassette (1) and let it dry.
• If you regularly clean the shaver under water, then once a week apply a drop of light
machine oil (not included) on top of the Foil & Cutter cassette and the long hair
trimmer.
Alternatively, you may clean the shaver with a brush:
• Switch off the shaver. Remove the Foil & Cutter cassette (1) and tap it out on a fl at
surface. Using a brush, clean the inner area of the pivoting head. However, do not
clean the foil and cutter cassette with the brush as this may damage it.
Keeping your shaver in top shape
Replacing the Foil & Cutter cassette / reset
To maintain 100% shaving performance, replace the Foil & Cutter cassette (1), when
the replacement symbol lights up on the shaver display (9) (after about 18 months) or
when cassette is worn.
The replacement symbol will remind you during the next 7 shaves to replace the
Foil & Cutter cassette. Then the shaver will automatically reset the display.
After you have replaced the Foil & Cutter cassette, use a ball-pen to push the reset
button (8) for at least 3 seconds to reset the counter.
While doing so, the replacement light blinks and goes off when the reset is complete.
The manual reset can be done at any time.
91508133_7720s_JP.indd 2291508133_7720s_JP.indd 22 24.07.17 08:1724.07.17 08:17
CSS APPROVED Effective Date 27Jul2017 GMT - Printed 04Sep2017 Page 22 of 28