To Next PageTo Next PageWhat to do if the cleaning valve on my Braun IS 7055 is hard to unscrew?
If the cleaning valve on your Braun Iron is difficult to unscrew, it's likely due to lime scale buildup. Turn the cap forcefully. To prevent this, rinse the system frequently.
What to do if my Braun IS 7055 is leaking water?
If you notice water drops from the holes in the bottom of the soleplate of your Braun Iron, it means water has condensed inside the tubes because steam is being used for the first time, or has not been used for some time. Press the steam button several times away from the ironing board to eliminate cold water from the steam circuit.
What to do if steam comes out under the base unit of my Braun Iron?
If steam is coming out from under the base unit of your Braun Iron, the “max” pressure safety system has opened. Turn the appliance off immediately and contact an authorized Braun Customer Service.
Why is steam or water leaking from the closure of my Braun IS 7055?
If steam or water is coming out from the closure of your Braun Iron, the closure is likely not tightened properly. Switch off the appliance, unplug it, and let it cool down for at least 2.5 hours. Unscrew the closure and screw it back on properly. Note that some water can escape when you unscrew the closure.
Why is the steam setting icon on, but no steam comes out of my Braun Iron?
If the steam setting icon is permanently on but there is no steam emission from the soleplate of your Braun Iron, the water tank float may be locked, or the water tank is not correctly inserted. To fix this, turn off and unplug the appliance. Remove and empty the water tank, rinse it out, and refill it. Reinsert the water tank and wait until the appliance has cooled down for at least 2.5 hours, then try again. If the problem persists, contact an authorized Braun Customer Service.
Why does my Braun Iron leak water from the soleplate?
If you notice water drops from the holes in the bottom of the soleplate of your Braun Iron, it's likely due to water condensation inside the tubes. This usually happens when steam is used for the first time or after a long period of inactivity. To resolve this, press the steam button several times away from the ironing board to eliminate any cold water from the steam circuit.
What to do if my Braun Iron doesn't switch on?
If your Braun Iron does not switch on, it might not be properly plugged into a mains socket. Make sure the appliance is correctly connected and press the On/Off button.
General| Power | 2400 W |
|---|---|
| Steam output | 50 g/min |
| Water tank capacity | 300 ml |
| Cord length | 2.5 m |
| Type | Steam Iron |
| Vertical steam | Yes |
| Pressure | 5 bar |
| Soleplate | Eloxal |
