12
MENU STRUCTURE / NAVIGATION
Set pressure level with l or rand con-
firm by pressing k.
Cancel to edit pressure by using c.
Pre-alarms are indicated by the message
on the display (e.g. “Syringe nearly
empty”), an audible tone and the yellow
LED is constantly on. To confirm a
pre-alarm press k.
In case of an operating alarm (e.g.
"Syringe empty") the infusion stops, an
audible tone sounds and the red LED is
flashing. Confirm alarm by using
k.
Confirming does not activate an acoustic
feedback
Press and hold o for 3 sec to turn pump
off. A white bar stretches from left to right
and counts down the 3 sec.
As long there is a syringe inserted the
pump will not turn off but will use stand-
by.
Display Meaning
This hint pops up if a user tries to edit or
change a parameter by pressing l when
that parameter is unable to be changed.
nb has been pressed while the pump is
infusing. Start manual bolus at
1200 ml/h by pressing k (see top of
display) or proceed to set bolus limit
with l (see bottom of display).
All status information is available in the
bottom line of the dislplay. The desired
information can be selected by using
d
u and will be displayed permanently
thereafter (e. g. drug long name, time until
syringe empty, current system pressure
etc.).
To Next Page
Loading...
Need help?
General