Why is my Braun Iron producing little to no steam?
If your Braun Iron isn't producing enough steam, there are a few things you can check: * First, ensure that the water tank has enough water and refill if needed. * Second, perform the descaling procedure. * Third, make sure the temperature selector is set to at least the "••" setting and wait for the iron to heat up completely, until the temperature control LED is permanently ON.
What to do if water droplets drip from my Braun TexStyle 7 Pro SI 71 Iron during ironing?
If you notice water droplets dripping from your Braun Iron while ironing, try these solutions: * Ensure the water tank lid is pressed firmly and completely closed. * Check that the temperature selector is set to at least "••". Select a higher temperature setting and use longer intervals when pressing the steam shot button. * If you've used chemicals in the water tank, empty it and rinse it thoroughly 2-3 times.
What to do if my Braun TexStyle 7 Pro SI 71 Iron soleplate is not heating up?
If the soleplate of your Braun Iron isn't heating up, unplug the iron, then plug it back in. Rotate the temperature selector from «min» to «max», and then select the desired temperature.
Why is my Braun TexStyle 7 Pro SI 71 spitting out flakes and white impurities?
If your Braun Iron is emitting flakes and white impurities from the soleplate, you should perform the descaling procedure.
What to do if the temperature control LED turns permanently on on my Braun TexStyle 7 Pro SI 71 Iron?
If the temperature control LED on your Braun Iron stays on continuously, try unplugging the iron and plugging it back in again. Also, set the steam regulator to «0».
To Next Page
General