BRAX NOX4 DSP - Troubleshooting

TROUBLE-SHOOTING
The BRAX NOX4 DSP is in protection mode and the respective LED lights up yellow.
Cause: The speaker wiring is faulty (short circuit between the wires or to the chassis of the vehicle).
Remedy: Check the speaker wires or the speakers themselves for short-circuiting (p.18-20).
The BRAX NOX4 DSP is in protection mode and the respective LED lights up red.
&DXVH 7KHDPSOL¿HULVRYHUKHDWHG,WFRXOGWDNHVRPHWLPHGHSHQGLQJRQWKHRXWVLGHWHPSHUDWXUHXQWLOWKHDPSOL-
¿HUWXUQVRQDJDLQ
The output level of the NOX4 is too low in bridged mode
&DXVH 7KHFKDQQHOURXWLQJLQWKHLQWHUQDO'63LVQRWFRQ¿JXUHGFRUUHFWO\
Remedy: It is necessary to assign both bridged channels in bridged mode an identical channel routing. It means to
assign both output channels the same input channels.. Please read carefully the DSP PC-Tool instruction
PDQXDO)XUWKHUPRUHSD\DWWHQWLRQWRDGMXVWDOVRWKHHTXDOL]LQJKLJKDQGORZSDVV¿OWHUWKHSKDVHDQGWLPH
DOLJQPHQWLGHQWLFDOO\)RUDQHDVLHUFRQ¿JXUDWLRQWKH'633&7RROVRIWZDUHSURYLGHVDFKDQQHOOLQNIXQFWLRQ
Comprehensive operating instructions for the DSP PC-Tool can be downloaded at ZZZDXGLRWHFÀVFKHUFRP
30