BRAX NOX4 DSP - Page 9

4 CPS - Colour Protection System
7KH/('VVKRZWKHRSHUDWLRQVWDWXVRIWKHDPSOL¿HU<HOORZ PDOIXQFWLRQVKRUWFLUFXLWDWVSHDNHURXWSXW
Red (12) = overheated: If the amp shuts off due to overheating it will take some time (depending on the outside tempera-
ture) until it turns on again.
5-6 Connectors for a BRAX Power Stabilizer
If a BRAX Power Stabilizer is connected to this terminal peak loads in the power supply will be eliminated. Thus, the am-
SOL¿HUKDVDOZD\VHQRXJKSRZHUIRULWVSHUIHFWSHUIRUPDQFH
Equipment and control units
7 Loudspeaker terminals
To connect the speaker cables. Never connect the loudspeaker cables with the car chassis ground. It damages your
DPSOL¿HU All speaker systems must be connected in-phase, it means plus to plus and minus to minus. Inverting plus and
minus will result in the loss of bass rendition. The positive terminal is marked on most speakers.
8 USB-Port
7KLVPLQL86%LQSXWLVXVHGWRFRQQHFWDFRPSXWHUZLWKWKHVXSSOLHG86%FDEOH7KH'63FDQEHIUHHO\FRQ¿JXUHGYLDWKLV
USB port and the PC-Tool software.
9 MicroSD card reader
7KH0LFUR6'FDUGUHDGHUFDQEHXVHGWRGRZQORDG¿UPZDUHDQGVRIWZDUHXSGDWHVDVZHOODVFRPSOHWH'63VHWXS¿OHV
containing all DSP settings. The seWXS¿OHLVFRSLHGDXWRPDWLFDOO\WRWKH12;'63ZKHQWKHFDUGµVLQVHUWHG&RS\LQJLV
VKRZQE\WKH6WDWXV/('EOLQNLQJUHGZKHQLWUHYHUWVWRJUHHQRURUDQJHFRS\LQJKDVEHHQFRPSOHWHG2QFHWKH¿OH
has been copied the card must be removed.
Attention: Do not remove the MicroSD card during copying.
7KH12;'63FDQKDQGOHWZRGLIIHUHQWVHWXS¿OHV7KHVH¿OHVKDYH³DI´³DF´³DI´RU³DF´VXI¿[HV8VHWKHFRQWURO
button (10) to toggle between them.
Please note:2QO\RQH³DI´RU³DI´VHWXS¿OHPD\EHRQWKHFDUG)LUPDQGVRIWZDUHXSGDWHVDUHDYDLODEOHIURPZZZ
DXGLRWHF¿VFKHUFRPRUZZZKHOL[KL¿FRP86
24