BRAX X 1400 - Connection of the Speaker Cables

Important!
Never connect the speaker cables to the vehicle chassis.
This can destroy your amplifier. Ensure that all the speaker
systems are connected in-phase, i.e. plus to plus and minus
to minus. The positive terminal is indicated on most spea-
kers. In addition, the amplifiers may be operated in
2-channel mode (see Fig. 5), 3-channel mode (see Fig. 6)
and 4-channel mode (see Fig. 7).
The mono/stereo selector switch is located at the bottom
of the amplifier. The function of the switch is described on
a label at the bottom of the amplifier (see Fig. 4).
Fig. 5: 2-Channel Mode
Fig. 6: 3-Channel Mode
Fig. 7: 4-Channel Mode
6
Connection of the Speaker Cables
Mono InputMono Input
Front right Rear right
Mono Input
Rear right
Fig. 4: Stereo/mono selector switch
Position of selector switch at the bottom Rear = Mono
of the amplifier: Front = Mono (see Fig. 4)
Position of selector switch at the bottom Rear = Mono
of the amplifier: Front = Stereo (see Fig. 4)
Position of selector switch at the bottom Rear = Stereo
of the amplifier: Front = Stereo (see Fig. 4)