SERIES 6A ELECTROPNEUMATIC POSITIONER
QUICK START GUIDE
11 of 12© 2021 BRAY INTERNATIONAL, INC. ALL RIGHTS RESERVED. BRAY.COM The Information
contained herein shall not be copied, transferred, conveyed, or displayed in any manner that would
violate its proprietary nature without the express written permission of Bray International, Inc.
POSITIONER OPTIMIZATION (Continued)
Step
Use the Menu Button
to scroll to
parameter (YCUP full open)
Step Change the parameter to the desired
upper limit for full open
Example If the positioner is at or
higher the actuator provides full force
open
Step Exit Configuration mode by pressing the
Menu Button
for seconds The
device will be in Manual Mode (“MAN’)
Press the Menu Button once to
leave the positioner in AUTO mode
To Next Page
Loading...
Need help?
General
