BRAYER BR4951 - Page 10

10
EN
• Press again the buttons (15 or 26) to set the timer
operation time. Timer operation time can be set from
1 hour to 15 hours with 1 hour setting step.
• To switch the timer o󰀨, press the button (15 or 26)
repeatedly until the digital symbols (18) on the
display (5) show the room temperature.
Switching the fan body oscillation on/o󰀨
• To switch the fan body oscillation on, press the button
(14) «OSC» on the control panel (5) or the button
(29) «Oscillatior» on the remote control (23) to switch
the oscillation o󰀨, press again the button (14) «OSC»
on the control panel (5) or button (29) «Oscillatior»
on the remote control (23).
Selecting the airow type
• Press the button (12) «WIND» on the control panel
(6) or the button (28) «WIND» on the remote control
(23), while the display (5) will show the symbol (19)
«
» - «natural wind», press the button (12 or 28)
again to switch the night mode on, the display (5) will
show the symbol (20) «
», to switch the night mode
o󰀨, press the button (12 or 28) again, the symbol (20)
«
» on the display (5) goes out.
Notes:
- «natural wind» is a natural wind imitating airow,
the airow speed is chaotically changing: from soft
breeze to strong gust of wind.
- «night mode» - the airow speed will increase and
decrease gradually;
• To switch the fan o󰀨, press the button (11) «ON/OFF»
on the control panel or the button (24) «ON/OFF» on
the remote control (23). The fan will be switched o󰀨
and the display (5) will go out.
Cool shot function
ATTENTION!During the hot season it is recommended
to regularly replace the water in the tank to avoid water
spoiling.
• Place the fan base (1) on a at, dry and steady
surface.
• •Make sure that the power plug is not inserted into
the mains socket.
• Remove the water tank lid (7).
• Fill the tank with clean water, do not exceed the
maximum water level mark «MAX» on the scale (2),
it is recommended to use water additionally cleaned
with a domestic lter.
Note: maximal capacity of the water tank is 5 l.
• Install the lid (7) back to its place.
Using the cool pack
ATTENTION! Do not leave children unattended to
prevent using the cool pack as a toy.
• For additional cooling of water, it is recommended to
use a cold pack (supplied with the unit).