BRAYER BR4951 - Cleaning and Maintenance

11
EN
Note: the cold pack can have two versions: with a
removable cover or with a sealed cover - this type of
cold pack does not need additional maintenance.
• Let’s take a look at the cold pack withremovable
cover:
- unscrew the lid and will the cold pack with water to
the «MAX» mark (pic. 5).
- wait 1-2 hours until the crystals in the cold pack
dissolve.
• •Place the cold pack in the freezer of the refrigerator
for several hours, until the liquid inside the cold pack
is completely frozen.
• Remove the water tank lid (7) and put the cold pack
in the water tanl, close the lid (7) (pic. 6).
• Note: - to avoid damage, be careful when putting the
cold pack into the water tank and removing it.
• Insert the power plug into the mains socket.
• Switch the fan on by pressing the button (11) «ON/
OFF» on the control panel or the button (24) «ON/
OFF» on the remote control (23), you will hear a
sound signal and the fan will switch on at low airow
speed, the symbol (17) «
» will light up on the
display (5).
Note: do not switch the cool shot function on when the
water tank is empty.
• To switch the cool shot function on, press the button
(14) «COOL» on the control panel (6) or the button
(27) «COOL» on the remote control (23), the symbol
(22) «
» will light up on the display. To switch the
cool shot function o󰀨, press the button (14 or 27)
again, the symbol (22) «
» on the display (5) will
go out.
• To switch the fan o󰀨, press the button (11) «ON/OFF»
on the control panel or the button (24) «ON/OFF» on
the remote control (23), the fan will be switched o󰀨
and the display (5) will go out.
• If it is necessary to transport the fan, remove the
lid (7), if the cold pack is installed, remove it and
carefully drain the water from the water tank.
• To avoid foreign odors, thoroughly dry the water tank
before packing and transporting the fan.
CLEANING AND MAINTENANCE
• Before cleaning the fan, switch it o󰀨 and unplug it.
• Wipe the fan body with a slightly damp cloth and then
wipe it dry.
• Do not use liquid detergents, abrasive cleaners and
any solvents to clean the fan (3).
• To avoid the risk of electric shock provide that no
water or other liquid gets into the fan body.
• To clean the air inlet grid (8), use a vacuum cleaner
with a corresponding attachment. Press on the
clamps (9) and remove the grid (8), clean the grid
with a vacuum cleaner and then install it back to its
place.