BRAYER BR4951 - Using the Fan

9
EN
• When you use the remote control, direct it to the front
part of the fan body (3).
• The distance between the remote control and the fan
should not exceed 5 m, the coverage angle should
be up to 30 degrees.
• Avoid exposing the receiver to direct sunlight,
otherwise false activation of control commands is
possible.
USING THE FAN
• Use the handle (10) to carry the fan.
• Place the fan base (1) on a at, dry and steady
surface.
• Do not place the fanon soft surfaces, such as carpets
with high pile, sofas or beds.
• Insert the power cord plug into the mains socket, you
will hear a sound signal.
Switching the fan on/o󰀨 and selecting the airow
speed
Notes:
- the buttons on the control panel (6) are sensory,
you just need to touch the button to switch the
necessary operation mode on;
- each pressing of buttons on the control panel (6)
or on the remote control (23) is accompanied with
a sound signal;
- if no buttons are pressed, then the display (5)
illumination will go out after 1 minutes. Digital
indications will go out after 3 minutes. To switch the
display on, press any button on the control panel (6)
or on the remote control (23).
• To switch the fan on, press the button (11) «ON/OFF»
on the control panel (5) or the button (24) «ON/OFF»
on the remote control (23), you will hear a sound
signal, and the fan will switch on at low airow speed,
the symbol (17) «
» will light up on the display (5).
• The digital symbols (18) on the display (5) will show
the air temperature in the room.
Note: the temperature digital indications (18) may
be slightly di󰀨erent from the readings of another
thermometer.
• Pressing the button (16) «SPEED» on the control
panel (6) or the button (23) «SPEED» on the remote
control (23) you can select the airow speed, the
symbols (17) «
, , » will appear on the display.
• To switch the fan o󰀨, press the button (11) «ON/OFF»
on the control panel or the button (24) «ON/OFF» on
the remote control (23). The fan will be switched o󰀨
and the display (5) will go out.
Fan operation time timer
• To set the operating time of the fan, press the button
(15) «TIMER» on the control panel (6) or the button
(26) «TIMER» on the remote control (23), you will hear
a sound signal, the ashing digits (18) on the display
(5) will how the timer operation time «0 0» and the
symbol (21) «
».