8
BEFORE THE FIRST USE
After the unit’s transportation or storage at negative
temperature, unpack it and wait for at least 3 hours
before using it.
• Unpack the unit and remove all the packaging
materials.
• Keep the original package.
• Read the safety measures and operating
recommendations.
• Check the delivery set.
• Examine the unit for damages, in case of damage do
not plug it into the mains.
• Make sure that specied specications of power
supply voltage of the unit correspond to the
specications of your mains. When using the unit in
the mains with 60 Hz frequency, the unit does not
need any additional settings.
• Wipe the fan body with a slightly damp cloth and then
wipe it dry.
ASSEMBLING THE FAN
• The fan is delivered with a disassembled base (1).
Do not switch the fan on without the base (1).
• Use a crosshead or at tip screwdriver (not supplied)
to assemble the base (1).
• Position the fan body (3) horizontally.
• Assemble the base (1): superpose the halves of the
base (1) (pic. 1) and x them with 2 fastening screws
(pic. 2).
• Attach the base (1) to the bottom part of the fan body
(3) with 4 fastening screws (pic. 3).
• Place the fan vertically on the base (1).
Remote control (23)
ATTENTION! A lithium battery is used in the remote
control. To avoid danger, do not allow children to
play with the battery. If your child has swallowed
a battery, immediately see a doctor. Battery
installation/replacing (pic. 4)
• Press on the clamp and remove the battery holder
(30) from the remote
• control (23) body, insert a CR2025 battery (supplied
with the unit) into the holder, strictly following the
polarity.
• Install the battery holder (30) into the remote control
(23).
Notes:
- if there is an isolation insert in the battery holder
(28), remove the insert;
- replace the battery in time;
- do not recharge the lithium battery;
- remove the battery if you are not planning to use
the unit for a long time;
- remove the used battery from the remote control
(23) and dispose of it.