Breas Vivo 45 LS User Manual

5.7.7 Using the Ventilator with the SpO
2
module
Information about safety, warnings, product description, installation, usage, cleaning,
maintenance and technical specifications can be found in the user instruction for
SpO
2
module.
The SpO
2
module enables connection to an SpO
2
sensor for measuring of functional
oxygen saturation of arterial haemoglobin (SpO
2
) and pulse rate. The SpO
2
module can
be connected to the Vivo 45 LS in order to monitor and store SpO
2
measurements.
The SpO
2
measurements will be stored in the data memory which can be downloaded
to a PC and viewed in the Breas PC software.
When installed, the Vivo 45 LS automatically detects the sensor, also after powering
off/on and after power failure.
5.7.8 Using the ventilator with the Remote Start/Stop
5.7.8.1 Connecting the Remote Start/Stop
1 Connect the Remote Start/Stop
cable to the ventilator.
Information about safety, warnings,
product description, installation, usage,
cleaning, maintenance and technical
specifications can be found in the user
instruction for Remote Start/Stop.
5.7.9 Using the ventilator with the Protective Cover
The protective cover is intended for additional protection of the ventilator during trans-
portation, and in hospital, institutional and home care environments. It can be used
while the ventilator is operating, for example mounted on a wheelchair, in a personal
vehicle, or carried by hand.
The protective cover protects the ventilator from environmental impact such as shock,
water spill, sunlight, dust and dirt, under normal handling.
The protective cover has the following functions:
106 How to Use the Vivo 45 LS
User manual
Doc. 007301 K-1

Breas Vivo 45 LS Specifications

General

Brand	Breas
Model	Vivo 45 LS
Category	Medical Equipment
Language	English