BREN Razor 700 Series User Manual

BREN 700-Series User Manual
Installation
2-11
Step 4
Put the bottom of machine in lateral, and position the Roll Holder Assembly beside the bottom
of the machine. Then, insert the M6 screws into the holes of Roll Holder support assembly
and tighten them with M6 L-shape screwdriver. Like Figure 2.3-3.
Step 5
Place the two roll holders into the holes of Roll Holder Support (Figure 2.3-4). To install the roll
holder with damper, please refer to chapter 2.2, step 8 to step 10.
Step 6
The complete Desktop Media Support System will be shown as in Figure 2.3-5.
Figure 2.3-5
Figure 2.3-3
M6 screws
Screw holes
Roll Holder Assembly
Figure 2.3-4
Roll Holders

BREN Razor 700 Series Specifications

General

Brand	BREN
Model	Razor 700 Series
Category	Cutter
Language	English