BREN Razor 700 Series User Manual

BREN 700-Series User Manual
Installation 2 -15
2.7 Cable Connection
The cutting plotter communicates with a computer through a USB (Universal Serial Bus), a
Serial port (RS-232C) or Ethernet. This chapter shows you how to connect the cutting plotter
to a host computer and how to set up the computer/cutting plotter interconnection.
!! Notice: When USB connection is enabled, serial port will be disabled automatically.
2.7.1 USB Interface
BREN 700-Series Razor build-in USB interface are based on the Universal Serial Bus
Specifications Revision 2.0 (Full Speed).
2.7.2 Connecting your BREN 700-Series Razor cutter
1. Turn on the machine.
2. Connect the USB connector to the machine and then start the BREN driver installation
process.
WINDOWS WILL DETECT USB AUTOMATICALLY BUT
CUTTER WILL NOT BE ABLE TO BE USED UNTIL
DRIVER IS INSTALLED CORRECTLY!!!
Figure 2-25
Serial Interface Connector (RS232C) –
used to connect the cutting plotter to a
computer through a serial interface cable.
USB Connector – used to connect the cutting
plotter to a computer through a USB cable.
Ethernet Connector– used to connect your
computer to a local area network.

BREN Razor 700 Series Specifications

General

Brand	BREN
Model	Razor 700 Series
Category	Cutter
Language	English