8
Care & Cleaning
EXTERNAL CLEANING OF UNIT
• Do not rinse the unit or immerse the unit
in water.
• Do not use abrasive cleaners or brushes
to clean.
• Clean the outside surface of the unit with
a soft cloth.
CHANGING THE FILTER
The filters used in this unit are not designed
to be washed or otherwise reused. When the life
of the filter reaches its end, the power icon will
flash red indicating that it needs to be changed.
While the length of time between filter changes
will vary based on the amount of use and the
conditions in which the unit is run, it will be
approximately every 6 months.
To replace the filter, turn off unit and disconnect
the power.
Turn the filter cover anti-clockwise and pull
outwards. Remove old filter and discard. Install
the new filter, ensuring that the white side
(HEPA) is facing outwards. Re-instate the filter
cover. To reset the filter timer, hold down the
Power Icon until it stops flashing.
CAUTION: Before carrying out cleaning or
maintenance of the product, always turn off and
unplug the cord from the power socket and unit.
To Next Page
Loading...
