Breville the Oracle Jet - Page 16

16
PROBLEM POSSIBLE CAUSE WHAT TO DO
Coee is grinding
very coarse,
even at low grind
settings and/or
cannot put the burr
back in place
• Upper burr many not be
aligned and not inserted
properly.
• Move the grind dial to a coarse setting
(i.e. 45), this will make it easier to twist it
counter clockwise to remove the upper burr
holder. Clean grinds from both the upper
and lower burrs. Ensure the dots on the
upper burr are aligned before aligning it
back to the dot on the lower burr by twisting
it clockwise. Move the grind dial back to the
original setting.
Espresso runs out
around the edge
of the portalter
and/or
Portalter comes
out of the group
head during an
extraction
• Portalter not inserted in
the group head correctly.
• Ensure portalter is rotated to the right
until the handle is past the center and is
securely locked in place. Rotating past the
center will not damage the silicone seal.
• There are coee grounds
around the lter basket rim.
• Clean excess coee from the rim of the
lter basket after grinding to ensure
a proper seal in group head.
• Filter basket rim is wet
or underside of portalter
lugs are wet. Wet surfaces
reduce the friction required
to hold the portalter in
place whilst under pressure
during an extraction.
• Always ensure lter basket and portalter
are dried thoroughly before lling with
coee, tamping and inserting into the
group head.
Pumps continue
to operate / Steam
is very wet / Hot
water outlet leaks
• Using highly ltered,
demineralised or distilled
water which is aecting
how the machine is
designed to function.
• We recommend using cold, ltered water.
We do not recommend using water with
no/low mineral content such as highly
ltered, demineralised or distilled water.
If the problem persists, contact Breville
Consumer Support.
Water does not ow
from the group head
• Water tank is empty. • Fill tank. Prime the system by:
1) Touching the ‘Brew’ button to run water
through the group head for 30 seconds.
2) Touching ‘Hot Water’ to run water through
the hot water outlet for 30 seconds.
• Water tank not fully
inserted & locked.
• Push water tank in fully and lock
latch closed.
• Over heated water pump
due to back-to-back
extraction.
• Switch o the machine and unplug
from the power outlet and let the machine
cool down.
The machine is ‘On’
but won’t operate
• Switch o the machine, unplug from the
power outlet, then plug the machine to the
power outlet and turn the machine back on.
• If problem persists, call Breville
Consumer Support.