5
getting started
IMPORTANT FIRST STEPS
Before using your Breville
®
PrimaLatte™ you need to clean it then prime it following the steps below.
1. Remove any packaging, stickers or labels.
2. Remove the water tank then remove the red shipping plug from the bottom of the tank. Discard the plug
(g.A).Theunitwillnotworkunlessyouremovethisplug.
3. Washthewatertank,milktank,lterholder,ltersandmeasuringspooninwarmsoapywater.Rinse
thoroughly.
4. Fillthewatertankwithcoldtapwater(g.B).Don’texceedtheMAXmarking.Retthetank.
5. Fillthemilktankwithcoldtapwater(g.C).Don’texceedtheMAXmarking.Retthetank.Themilk
tankisatighttandyouwillhavetoholdthemainunitinordertoapplysufcentforcetopushitall
the way in. The Cappuccino button and Latte button lights will only come on when the milk tank is
correctlytted.
6. Fitanyoneoftheltersintothelterholder,thentandlockthelterholdertothebrewhead—see
usingthelterholderformoredetails.Placealargecup(approx.250–300ml)underthelterholder
(g.D).
7. Plug your Breville
®
PrimaLatte™intoapowersocketandsettheon/offswitchtoON.
8. Thethreebuttonlightswillashslowlywhiletheunitisheatingup.Oncetheystopashingandremain
lit, press and hold the Espressobuttonfor3seconds.Waterwillowintothecup.Waituntilthewater
stopsowing(thethreebuttonswilllightup).
9. Emptythecupandreplaceitunderthelterholder.Positionthemilkfrothtubeoverthecupusingthe
milk froth tube lever (Fig. E). Press and hold the Cappuccino button for 3 seconds. Wait until steam
andwaterstopowingfromthefrothtube(thethreebuttonswilllightup).YourBreville
®
PrimaLatte™
isnowreadytousehowever,youwillneedtollthemilktankwithmilkifyouaregoingtomake
CappuccinoorLattedrinksorusethemilkfrother.
1. Brewing head
2. Milkfrothtube
3. Heightadjustmenttray
4. Drip tray and cover
5. Water tank (at rear of the unit)
6. Espresso button
7. Cappuccinobutton
8. Latte button
9. Froth control
10. Froth tube lever
11. Milktank
12. On/offswitch(onthesideoftheunit)
13. Singleshotlter
14. Doubleshotlter
15. ESEpodlter
16. Filter lock
17. Filter holder
18. Scoop/tamper
PARTS AND CONTROLS
Sleep mode
If you leave the unit on for 15 minutes without using it, it will go into sleep mode and the three button lights
will go out. Press any button to reactivate it.