4
Memory Function in Manual Mode
1. Press MANUAL/PAUSE button in edit page for 5 seconds and release it. You have then stored the last setting.
There is a ringing sound for successful storing.
2. Press START button after the above operation and the Brewster will continue to perform the set program.
3. Press STOP button to stop the Brewster
4. Long press AUTO/PAUSE button in BLANK PAGE as below (display show current temperature only as below) for
5 seconds to restore factory settings, there is a slow ringing for restoring successfully.
Auto Mode Setting
1. Switch on the device, then press AUTO button.
2. S1 will be shown on the top left corner, input the 3 settings - TEMP, TIMER and POWER (as above).
3. After you have set the 1
st
program, press AUTO button again then proceed to the 2
nd
program setting. 3
rd
to 9
th
programs are set as 1
st
and 2
nd
.
4. When you have entered up to 9 steps as you require, press the START button to confirm the above step mashing
settings.
5. The steps after boiling will be skipped if 9 steps are too many for your recipe. This program only supports one
boiling setting in each recipe. However, you can adjust the boiling power during operation anytime.
6. When S1 temperature is reached, there is reminder ringing, timer will not countdown unless you press AUTO
button to confirm. It is ingredients filling reminder.
7. The boiling reminder is same as above, when machine finish the step before boiling, there is reminder ringing,
program will not enter boiling step unless you press AUTO button for confirmation. It is sparging reminder.
8. PAUSE button will stop the heating and timer working temporarily, and you can amend the data, afterwards press
AUTO to continue.
9. Press START button when auto mode is running, you can skip the step you if not needed.
10. Setting hop reminder in boiling process, press - or + for countdown timer setting. Press TIMER button for 2
nd
,
3
rd
...9
th
setting. The countdown timer should be set with the longest time first e.g. 60 min., 30 min., 15 min., 5
min., etc. Press START button start to heat.
11. Long pressing POWER and TIMER buttons for 5s in BLANK PAGE, operation enter to recipe selection. Press
"-" or "+" to choose required recipe. Recipe storage is up to 9 programs. Press Start button to confirm the
selected recipe, BLANK PAGE will be shown on display, then press AUTO/PAUSE button to enter the chosen
recipe edit page. You can press START button to run the selected program or press AUTO/PAUSE button to
edit/check the program step by step.
12. If you press STOP button to skip all the steps, the Brewster will stop working, and the display will show END, an
alarm will ring for 30 sec., press the STOP button again to enter BLANK PAGE.
Memory Function in Auto Mode
1. After setting all the data you need in auto mode, press STOP button until BLANK PAGE. Please do not switch
off the machine! Follow below step for storing.
2. Press MANUAL button to enter manual edit page, then long press MANUAL button for 5 seconds and then
release it. You have now stored the last manual and auto mode setting. There is ringing sound for successful
storing.
3. Switch off/on the machine, then press AUTO button, the 1st step of last chosen program will be shown on the
display.
4. Press START button, machine start working.
5. The program does not support batch storage. Each recording needs to repeat above instruction.
To Next Page
Loading...
Need help?
General