Operation and Safety Manual
™
Model 330IK SA Semi-Automatic Gear Driven Gravity Feed Slicer
The Brice Model 330IK SA Semi-Automatic slicer has been designed for environments where
a range of different foodstuffs and slicing requirements must be met - from individual slices to
large batches (up to 60 slices per minute). Its features include:
•
Manufactured in anodised aluminium and stainless steel to resist oxidisation and corrosion;
•
Switch-selectable Manual or Automatic operation
•
Programmable stroke length and stroke speed for optimum cutting efficiency;
•
Micrometric thickness control allows for cutting of slices from 0 to 24mm;
•
Integrated control panel with status lights and an illuminated thickness indicator;
•
Low voltage switching for added safety;
•
Last Slice device to minimise waste in slicing processed foodstuff stubs;
•
Self-contained and built-in sharpening device with grinding and finishing stones;
•
All bearings are self-lubricating and sealed-for-life;
•
Powerful gear-driven blade;
•
Safety cutout switches for centre plate;
•
Fully-guarded blade and meat tray.
Components of the model range
The following picture illustrates the main components of the slicer.
The Brice Model
330IK SA Gear
Driven Gravity
Feed Semi-
Automatic slicer
Introduction 1.3
1 Control Panel/Power switch
2 Thickness control
3 Carriage pusher handle
4 Carriage securing knob
5 Meat table carriage
6 Product fence securing knob
7 Product fence
8 Blade cover
9 Blade guard
10 Sharpener
11 Meat grip/Last slice device
12 Last slice device arm
13 Thickness plate
14 Safety guard
15 Blade cover locking knob
16 Slice deflector
17 Auto/Manual selector
1
2
3
4
6
7
8
9
10
5
11
12
14
13
14
15
16
17
Installing the
slicer
Positioning the slicer
No matter where you put the slicer, you must allow at least as much space as the overall dimen-
sions indicate. Allowing an additional minimum of 20cm either side of the slicer will make access
for cleaning and maintenance easier.
Make sure that the surface that you intend placing the slicer on is solid, flat, level, dry and
smooth. Ideally, the surface should be between 80cm and 90cm high.
Electrical connections
The slicer connects to a single phase 240 Volts power supply using the power cord supplied.
Simply connect the plug on the end of the power cord to the power point.
To Next Page
