Bricon 100 - Programming the Antennas; Set up

8
You can set up your language (see Set up your language.).
3.1. Programming the antennas.
Before you can start with the Bricon Electronic Clocking Device, the
antennas need
to be programmed. Make the set up as demonstrated in item Set up. After
the set up, follow the steps below.
- Little 1000 -
>Clocking
Menu
Time : 16:14:16
When you connect the EC, wait for a long
beep and a few seconds later a short beep.
Then press <C>.
Here the start up menu is shown on the
display.
- Little 1000 -
Clocking
>Menu
Time : 16:14:18
Press the “↓” key on the keyboard of the EC
till “Menu” is selected.
Press <OK>.
- MENU (5)-
1.Race
2.Use data
>3.Options
4.Set up
5.PC-Interface
On the new display 5 submenus appear. (The
number between brackets indicates the
number of submenus.) We only see 3
submenus. By pressing “↓” , or by entering
the figure before the submenu on the EC, a
submenu can be selected. Select “Options”.
Press <OK>.
- OPTIONS (3)-
1.Pigeon list.
>2.Prog.Anten
3.AntenTest
Select “Prog. Antenna.”.
Press <OK>.
Disconnect
antennas.
<OK>
Disconnect the antennas.
Press <OK>.