Bridgeport GX 710 - Page 19

Page 19
SINCE 2000
1.For running smoothly, never accumulate too many
chips on conveyor ,which may easily cause conveyor
jammed or broke down.
2.Once conveyor is jammed or broke down,please let
conveyor reversed turn to expel chips first by push
"REV" button.after chips come out ,then push "FOR"
button to let conveyor run forward to work.
WARNING
Step blades and chain on conveyor
can injure hands easily.Please shut
off power of chip
maintenance
FANDE INDUSTRIES CO., LTD.
TAICHUNG 407, TAIWAN
PARK,
52-1, ROAD 39, TAICHUNG INDUSTRIAL
TEL : 886-4-23507286 FAX : 886-4-23507287
Optional swarf conveyor
FAILURE TO USE PROPER TOOL HOLDER
THIS MACHINE IS CON FIGURED T O USE
MAY RESULT IN PERSONAL INJURY OR
THAT CONFORM TO JMTBA STANDARD
MAY RESULT IN PERSONAL INJURY
THIS MACHINE IS CONFIGURED TO
USE THE FOLLOWING TOOL STUD ONLY
TYPE: JMTBA STANDARD MAS 403-1982
#40 BT TAPER TOOL HOLDE RS
MACHINE DAMA GE
MAS 403-1982
FAILURE TO USE PROPER STUD
OR MACHINE DAMAGE
P40T SPECIAL, METRIC THREADS
#40 BT TAPER, 45 DEGREE
TOOL RELEASE
FAILURE TO USE PROPER TOOL HOLDER
THIS MACHINE IS CONFIGURED TO USE
MAY RESULT IN PERSONAL INJURY OR
THAT CONFORM TO JMTBA STANDARD
MAY RESULT IN PERSONAL INJURY
THIS MACHINE IS CONFIGURED TO
USE THE FOLLOWING TOOL STUD ONLY
TYPE: JMTBA STANDARD MAS 403-1982
#40 BT TAPER TOOL HOLDERS
MACHINE DAMAGE
MAS 403-1982
FAILURE TO USE PROPER STUD
OR MACHINE DAMAGE
P40T SPECIAL, METRIC THREADS
#40 BT TAPER , 45 DEGREE
NV 001030323A
TOOL RELEASE
+X -X
-Y
+Z
-Z
+Y
+X
-X
-Y
+Z
-Z
+Y
NV 001030316A
NVA001030354A
Max Spindle Speed(RPM):
Max. Table Load(kg):
Max Tool Weight(kg):
Max Tool Diameter(mm):
Max Tool Length(mm):
Max Spindle Speed(RPM) :
Max. Table Load(kg):
Max Tool Weight(kg):
Max Tool Diameter(mm) :
Max Tool Length(mm):
NV 001030243A
NV 001030317A
NV 001030350A
SUPER GX 710 Front View