What to do if my Brigade Measuring Instruments experience system power loss?
If your Brigade Measuring Instruments are experiencing system power loss, consider the following: The vehicle battery should be replaced if it is suspected of malfunctioning. Ensure the low voltage protection feature is turned on. Check if any fuses are blown and replace them if necessary.
Why am I experiencing video loss with my Brigade MDR 600?
If you're experiencing video loss with your Brigade Measuring Instruments, make sure cables are not installed in areas where they can be tampered with. Also, ensure cable connectors are secure before driving.
How to fix no recording on SD or HDD/SSD issue with Brigade MDR 600?
To fix a 'no recording' issue on your Brigade Measuring Instruments, ensure that the overwrite feature is turned on. Additionally, consider installing a larger capacity HDD/SSD or a 256GB SD card.
How to troubleshoot docking station failure in Brigade MDR 600 Measuring Instruments?
To troubleshoot docking station failure in your Brigade Measuring Instruments, ensure the MCU key is locked and that wires being used are protected by heat shrink.
What to do if Brigade MDR 600 fail due to environmental conditions?
If your Brigade Measuring Instruments fail due to environmental conditions, the driver should wait a few minutes for the internal heater to heat the HDD to above 10°C. The device will then start to record.
General| Brand | Brigade |
|---|---|
| Model | MDR 600 Series |
| Category | Measuring Instruments |
| Language | English |
To Next Page
