Why Briggs & Stratton switch doesn't transfer to generator?
If your Briggs & Stratton switch isn't transferring to generator power, it could be due to an open generator breaker. Try resetting the generator circuit breaker. Another potential cause is unacceptable generator voltage. In this case, you should refer to the generator manual for troubleshooting steps.
What to do if Briggs & Stratton 01813-1 doesn't transfer to utility?
If your Briggs & Stratton switch isn't transferring back to utility power, several factors could be at play. First, check if the utility disconnect breaker is open and reset it (Models 01928-1 & 01929-1 only). Also, check the service disconnect breaker and reset it if necessary. Finally, the utility voltage might be unacceptable; in this case, wait for the utility voltage to return to normal.
Why is Briggs & Stratton generator still running after utility power is restored?
If the generator continues to run after utility power is restored, it might be because the minimum engine run time hasn't elapsed. Allow five minutes for the transfer switch to retransfer to utility power. Another possibility is a defective fuse in the transfer switch. Inspect the fuse(s) and replace them if necessary.
How to stop Briggs & Stratton generator after switch transfers to utility power?
If your Briggs & Stratton generator keeps running after the switch transfers to utility power, it may be due to the engine cool down period. The engine should stop after 1 minute.
What to do if supervised loads operate when Briggs & Stratton generator is supplying power?
If supervised loads are running while the generator is supplying power, the NC contacts may not be operating correctly. Check the NC contacts for proper operation and/or check the control wiring to the external load.
Covers all types of warnings and cautions for safe operation and installation.
Covers inspection upon delivery and unpacking procedures.
Recommendations for securely installing the transfer switch.
Connecting power supply, load, utility, and generator wiring.
The process of switching from utility to standby power.
Lists common problems, causes, and solutions.
General| Brand | Briggs & Stratton |
|---|---|
| Model | 01813-1 |
| Category | Switch |
| Language | English |
To Next Page
