Briggs & Stratton 150000 User Manual

Operator’s Manual
BRIGGSandSTRATTON.com
ECopyright Briggs & Stratton Corporation
Milwaukee, Wisconsin 53201 U.S.A.
Form No. 277040-3/07
Printed in U.S.A.
Model 200000
Power Built 1350/1450 Series
Intek I/C 1350/1450 Series
I/C 1450 Series
Model 120000
Power Built 825/850/875/900 Series
Intek I/C 825/850/875/900 Series
I/C 825/850/875 Series
Model 150000
Power Built 1100/1125 Series
Model 210000
Power Built 1500/1575 Series
Intek I/C 1500/1575 Series

Briggs & Stratton 150000 Specifications

General

Brand	Briggs & Stratton
Model	150000
Category	Engine
Language	English

Summary

Safety

Symbols And Warnings

Explains safety alert symbols, signal words, and hazard symbols used in the manual.

Features

Operation

Oil Capacity and Recommendation

Details engine oil capacity and recommended oil viscosity based on temperature.

Check and Add Oil

Provides instructions on how to check and add engine oil using different dipstick types.

Fuel Recommendations

Specifies required gasoline quality, acceptable additives, and high-altitude usage.

Add Fuel

Safety precautions and steps for refueling the engine, including proper cap usage.

How To Start The Engine

Step-by-step guide for starting the engine, including pre-start checks and operation of controls.

How To Stop The Engine

Procedure for safely shutting down the engine using throttle control and/or ON/OFF switch.

Maintenance

Maintenance Chart

Provides a schedule for regular maintenance tasks based on operating hours.

Inspect Muffler and Spark Arrester

Instructions for inspecting and replacing the muffler and spark arrester components.

Carburetor Adjustment

Advises against carburetor adjustments and recommends consulting a service dealer.

Valve Clearance

Specifies the interval for checking valve clearance and refers to the tune-up specifications.

Spark Plug

Details how to check, clean, and gap the spark plug, including replacement recommendations.

How To Change The Oil

Step-by-step guide for draining old oil and refilling the engine with new oil.

How To Service The Air Filter

Instructions for cleaning and replacing air filter components, including pre-cleaners.

How To Change The Gear Reduction Oil

Procedure for changing the oil in the optional gear reduction unit.

How To Replace The Fuel Filter

Steps for safely removing and replacing the fuel filter, including fuel line clamp management.

Clean Air Cooling System

Guidance on cleaning the engine's air cooling system to prevent overheating.

Storage (over 30 days)

Procedures for preparing the engine for long-term storage, including fuel and oil management.

Troubleshooting

Specifications

Engine Specifications and Common Service Parts

Details engine dimensions, displacement, bore, stroke, and common replacement parts with part numbers.

Tune-up Specifications

Provides specific gap and clearance values for spark plugs, armature air, intake, and exhaust.

General Information and Power Rating

Describes engine type, emissions certification, and factors affecting engine power ratings.

Warranties

Limited Warranty Policy

Outlines the terms, conditions, and exclusions of the Briggs & Stratton engine warranty.

Warranty Terms by Brand and Use

Specifies warranty periods for different engine types and usage (consumer vs. commercial).

About Your Warranty and Causes for Exclusion

Explains warranty service procedures and common causes for warranty denial.

California, US, and Canada Emissions Control Defects Warranty

Details the warranty coverage for emissions control parts and components.

Owner's Warranty Responsibilities

Outlines owner's responsibilities for maintenance and proper engine operation.

Emissions Control Defects Warranty Provisions

Specific provisions for warranted parts, coverage length, and exclusions for emissions warranty.

Emissions Durability and Air Index Information

Explains emissions durability periods and air index for engine certification categories.