Need help?Do you have a question about the Briggs & Stratton 130G00 and is the answer not in the manual?
General| Brand | Briggs & Stratton |
|---|---|
| Model | 130G00 |
| Category | Engine |
| Language | English |
Explains safety alert symbols, signal words (DANGER, WARNING, CAUTION), and general safety messages for engine operation.
Details engine identification, fuel, oil, high altitude, and storage recommendations for proper engine care.
Outlines recommended maintenance tasks based on operating hours or time intervals for optimal engine performance.
Provides step-by-step instructions for changing and checking engine oil levels to ensure proper lubrication.
Explains how to clean or replace air filters and pre-cleaners to maintain engine air intake efficiency.
Details cleaning and inspection procedures for the muffler and spark arrester to ensure proper exhaust function.
Steps for cleaning, gapping, or replacing the spark plug for reliable ignition.
How to clean the carburetor sediment bowl, including safety precautions for fuel handling.
Step-by-step guide to check and adjust valve clearance for optimal engine timing and performance.
Addresses common engine complaints and provides systematic checks for ignition, carburetion, and compression issues.
Lists specialized tools required for various service and repair procedures.
General steps before removing external assemblies, like emptying fuel and disconnecting spark plug wire.
General information on air cleaner configurations and steps to remove them.
Instructions for removing the starter motor assembly from the engine.
Steps for removing the fuel tank and associated fuel lines.
Instructions for removing the carburetor and its adapter components.
Steps to remove the muffler and its associated gasket.
Steps for removing the blower housing, noting attached components.
Procedures for disassembling the top end of the engine, including cylinder head and valve train.
Procedures for disassembling the bottom end of the engine, including crankshaft and piston removal.
Detailed service procedures for the cylinder head, including disassembly, cleaning, and inspection.
Service procedures for pistons, rings, pins, and connecting rods, including inspection and assembly.
Service procedures for the flywheel, crankshaft, and camshaft, including cleaning and inspection.
Service procedures for the crankcase and cover, including bearing and seal replacement.
Step-by-step instructions for assembling the bottom end of the engine, including crankshaft and piston installation.
Step-by-step instructions for assembling the top end of the engine, including cylinder head and valve train reassembly.
Instructions for installing the armature, including setting the air gap for proper ignition.
Steps for installing the carburetor and its related components, including overhaul instructions.
Instructions for installing the rewind starter assembly and replacing the rope.
Steps for installing the fuel tank and its associated fittings and hoses, including filter replacement.
Instructions for installing various types of air cleaner assemblies, including dual element, oil bath, and foam filters.
Installation procedures for 6:1 and 2:1 gear reduction units.
Provides detailed engine specifications for models 130G00, 131G00, 13R200.
Lists torque values for various fasteners critical for engine assembly for models 130G00, 131G00, 13R200.
Lists standard and reject measurements for engine components for models 130G00, 131G00, 13R200.
Provides detailed engine specifications for models 13U100, 13U200.
Lists torque values for various fasteners critical for engine assembly for models 13U100, 13U200.
Lists standard and reject measurements for engine components for models 13U100, 13U200.
To Next Page