To Next PageTo Next Page
Need help?Do you have a question about the Briggs & Stratton 133200 Series and is the answer not in the manual?
General| Displacement | 344 cc |
|---|---|
| Fuel Type | Gasoline |
| Oil Capacity | 20 oz |
| Engine Type | 4-Stroke |
| Engine Configuration | Single Cylinder |
| Engine Design | Overhead Valve (OHV) |
| Starting System | Recoil |
Essential checks and warnings before starting the engine.
Defines safety alert symbols, signal words, and hazard symbols.
Guidelines for adding, storing fuel, and preventing fuel-related hazards.
Procedures and warnings for starting, operating, and transporting the engine safely.
Safety steps before performing adjustments, repairs, or testing.
Risks from carbon monoxide, hot surfaces, and combustible debris.
Risks associated with rotating parts and starter cord kickback.
Labeled diagram and list of engine parts.
Details bore, stroke, displacement, and operating notes.
Provides gap settings for armature and spark plug, and valve clearances.
Specifies engine oil capacity and recommended types for different temperatures.
Step-by-step guide for checking and adding engine oil.
Guidance on using clean, fresh, unleaded gasoline and avoiding certain additives.
Instructions and warnings for safely filling the fuel tank.
Explains Oil Gard®, low oil warnings, and general operating advice.
Step-by-step guide for starting the engine using the recoil starter.
Instructions for safely stopping the engine manually.
Step-by-step guide for starting the engine using an electric starter.
Instructions for safely stopping the engine using the electric starter.
Table outlining maintenance tasks and recommended intervals.
Detailed procedure for draining and refilling engine oil.
Procedure for changing oil in the gear reduction unit.
Instructions for removing, cleaning, and reinstalling the air cleaner.
Guidance on inspecting muffler, spark arrester, and fuel system integrity.
Procedures for spark plug service and cleaning the air cooling system.
Steps to adjust the throttle control linkage for proper operation.
How to adjust the idle speed screw for the carburetor.
Procedure for ensuring proper contact with the remote stop switch.
Lists common replacement parts and their part numbers for ordering.
Information on locating and utilizing authorized service dealers.
Guidelines for preparing the engine for long-term storage to prevent damage.
Details owner's responsibilities and warranty coverage for emission control parts.
Specific terms, conditions, and exclusions for emission warranty.
Lists common causes of engine failure not covered by warranty.
Outlines the general limited warranty terms and conditions.
Details the warranty duration for different engine series and usage types.
