EasyManua.ls Logo

Briggs & Stratton 133200 Series - Starting and Stopping Engines; Manual Recoil Start Procedure; Manual Engine Stop Procedure

Briggs & Stratton 133200 Series
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9
STARTING AND STOPPING
REWIND (MANUAL) STARTER
TO START ENGINE
Choke
[1] Check oil level (see p. 7).
[2] Move throttle (if equipped) to FAST. Operate engine with throttle in FAST.
[3] Move choke lever to CHOKE.
OIL LEVEL
Throttle
FULL
[4] Move stop lever (if
equipped) to ON.
[5] Grasp rope handle. Pull
slowly until resistance is
felt, then pull rapidly to
start engine and avoid
kickback.
[6] Let engine warm up.
Choke Equipped: Move
choke control lever
toward RUN a short dis-
tance at a time over sev-
eral seconds in warm
weather or minutes in cold
weather. Let engine run
smoothly before each
change. Operate with
choke in RUN.
WARNING
Stop
TO STOP ENGINE
CAUTION: Do not stop engine by moving choke
control to CHOKE. Backfire, fire or engine damage
could occur.
[1] Move throttle (if
equipped) to SLOW, then
to OFF/STOP.
[2] Move stop lever (if
equipped) to STOP/OFF.
Stop
OR
Throttle

Related product manuals