To Next PageTo Next Page
Need help?Do you have a question about the Briggs & Stratton 1695360 and is the answer not in the manual?
General| Engine Type | 4-Cycle OHV |
|---|---|
| Displacement | 208cc |
| Intake Height | 20 inches |
| Throw Distance | Up to 30 feet |
| Auger Type | Steel |
| Chute Control | Manual |
| Fuel Tank Capacity | 2.5 quarts |
| Starting System | Electric Start/Recoil |
General safety rules and operating practices for the snowthrower.
Pre-operation checks and safety measures.
Outlines safe operating procedures and cautions.
Safety precautions and guidelines for operating on slopes.
Instructions for assembling the hitch onto the tractor.
Steps to assemble the push bar latch.
Details bracket installation for different drive models.
Instructions for installing the lift lever kit.
Steps for installing the correct drive belt.
Instructions for installing the lock plate on hydraulic lift models.
Steps to slide the sub-frame hitch under the tractor.
Connects the lift lever assembly to the lift rod.
Steps to assemble the discharge chute.
Connects the snowthrower to the tractor hitch.
Mounts the support arm for the deflector control cable.
Attaches the front of the lift rod assembly to the lift arm.
Installation for units without electric height-of-cut.
Operation of chute rotation using a toggle switch.
Specific instructions for electric height-of-cut units.
Instructions for installing the spring anchor on older models.
How to hook the spring anchor assembly into the groove.
Brief description of individual control functions.
Familiarization with tractor and attachment controls.
Pre-operation checks and maintenance.
Guidance on engine throttle and ground speed.
Procedures for starting and stopping the unit.
Safe practices for transporting the snowthrower.
Tips for effective snow removal.
Procedures for daily storage of the snowthrower.
Steps for storing the snowthrower during the off-season.
How lift mechanism locks for downward force.
Lift link installation for specific tractor models.
Routine care schedule for the snowthrower.
Areas to lubricate with oil and grease.
Procedure to check and fill auger gearbox oil.
Procedure to check and fill impeller gearbox oil.
Lists common problems, causes, and remedies.
Adjusting skid shoes for surface contact.
Adjusting the electric chute rotator motor.
Information on auger shear pins.
Information on the impeller shear bolt.
Adjusting lift height and downward pressure.
Tightening bolt to increase lift assist.
Adjusting belt tension using the trunnion.
Steps for removing and installing a new drive belt.
