Briggs & Stratton 1696614-00

Questions and Answers

J
Joseph RichardsAug 10, 2025
Why Briggs & Stratton Snow Blower engine does not start?
- B
  brandon82Aug 10, 2025
  There are several reasons why your Briggs & Stratton snow blower engine might not be starting. It could be due to the key being in the OFF position, so ensure it is set to ON. If the engine is cold, the primer button may not have been pressed; try pressing it twice before restarting. Also, check if the fuel shut-off valve (if equipped) is in the CLOSED position and turn it to OPEN. The unit might be out of fuel, so fill the fuel tank. If it is a cold engine, the choke may be turned to OPEN/RUN, so turn the choke to CLOSED/START and set the throttle to FAST. Finally, the engine could be flooded; in that case, move the choke to OPEN/RUN, move the throttle to FAST, and crank until the engine starts.
S
Stacy ButlerAug 15, 2025
How to fix Briggs & Stratton 1696614-00 that starts hard?
- D
  dbrownAug 15, 2025
  If your Briggs & Stratton snow blower starts hard or runs poorly, it could be due to water or old fuel in the fuel tank. Drain the tank, dispose of the fuel at an authorized hazardous waste facility, and fill it with fresh fuel. Another cause could be a blocked fuel cap vent; try clearing the vent or replacing the fuel cap.
E
Erica HubbardAug 20, 2025
What to do if Briggs & Stratton Snow Blower does not discharge snow?
- C
  Chelsea WilsonAug 20, 2025
  If your Briggs & Stratton snow blower isn't discharging snow, immediately stop the engine. It's possible that the discharge chute is clogged. Always use the clean-out tool to clear it, never your hands. Also, there might be a foreign object lodged in the auger; again, stop the engine immediately and use the clean-out tool to remove the object, not your hands.
T
Tami RobertsAug 25, 2025
What to do if Briggs & Stratton Snow Blower has excessive vibration?
- J
  Jason StevensonAug 26, 2025
  If your Briggs & Stratton snow blower is vibrating excessively, stop the engine immediately. Check for loose parts and tighten all hardware. If the vibration continues, it could be due to a damaged impeller, and you should have the unit serviced by an authorized dealer.
C
cooperchristineAug 30, 2025
Why Briggs & Stratton Snow Blower unit does not discharge snow?
- S
  Suzanne CombsAug 30, 2025
  If your Briggs & Stratton snow blower isn't discharging snow, it could be due to an issue with the auger control cable being out of adjustment. Also, a broken auger shear bolt could be the cause.
E
Earl ThompsonSep 4, 2025
Why Briggs & Stratton 1696614-00 unit does not propel itself?
- J
  Joseph ValenciaSep 5, 2025
  If your Briggs & Stratton snow blower isn't propelling itself, the traction control cable might be out of adjustment.

Briggs & Stratton 1696614-00 Specifications

General

Engine Brand	Briggs & Stratton
Clearing Width	24 inches
Intake Height	20 inches
Starting System	Electric Start
Auger Diameter	12 inches
Deflector Control	Manual
Chute Control	Manual
Auger Material	Steel
Engine	4-cycle
Drive System	Friction Disc
Throw Distance	30 ft
Starter	Electric
Warranty	2 years
Chute Rotation	200 degrees