To Next PageTo Next PageWhy Briggs & Stratton PRO6500 Portable Generator will not start?
If your Briggs & Stratton Portable Generator won't start or runs rough, it could be due to a couple of reasons: * **Out of gasoline:** Simply fill the fuel tank. * **Low oil level:** Fill the crankcase to the proper level or place the generator on a level surface.
What to do if Briggs & Stratton PRO6500 shuts down during operation?
If your Briggs & Stratton Portable Generator shuts down during operation, consider these potential causes: 1. **Circuit breaker:** One of the circuit breakers may be open. Try resetting it. 2. **Fault in generator:** There may be a fault in the generator. Contact an authorized service facility. 3. **Connection issues:** A poor connection or defective cord set could be the culprit. Check and repair as necessary. 4. **Faulty device:** The connected device might be bad. Connect another device that is in good condition to test.
Why Briggs & Stratton Portable Generator runs good at no-load but "bogs" down when loads are connected?
If your Briggs & Stratton Portable Generator runs well with no load but bogs down when loads are connected, it could be due to: 1. **Short circuit:** A short circuit in a connected load. Disconnect the shorted electrical load. 2. **Overload:** The generator is overloaded. See "Don't Overload Generator" section. 3. **Shorted generator circuit:** There is a shorted generator circuit. Contact an Authorized service facility.
General| Model | PRO6500 |
|---|---|
| Fuel Type | Gasoline |
| Engine Brand | Briggs & Stratton |
| Engine Type | OHV |
| Engine Displacement | 420cc |
| Fuel Tank Capacity | 7.5 Gallons |
| Outlets | 4 |
| Voltage | 120/240V |
| Noise Level | 74 dB |
| Wheel Kit | Yes |
| Weight | 208 lbs |
| Starting Watts | 8125 watts |
| Running Watts | 6500 watts |
| Outlet Types | 120V 20A, 120V 30A, 120/240V 30A |
| Starting Method | Electric/Recoil |
