To Next Page
J
jmilesJul 29, 2025
How to fix a Briggs & Stratton SpeedClean 020212-0 Pressure Washer that is not producing pressure?
- MMichael LewisJul 29, 2025
To troubleshoot a Briggs & Stratton Pressure Washer that isn't producing pressure: * Ensure a high-pressure spray tip is installed, replacing it if a low-pressure tip is in place. * Check for and clear any blockages in the water inlet. * Verify an adequate water supply is available. * Inspect the inlet hose for kinks or leaks; straighten the hose or patch any leaks. * Examine and clean the inlet hose strainer if clogged. * Ensure the water supply temperature is not over 100°F; use a cooler water source if needed. * Clear any blockages in the high-pressure hose. * Replace the gun if it's leaking. * Clean the spray tip if obstructed. * If the pump is faulty, contact an authorized service facility.
General
