Brighter Smart 1000 - Page 8

8
Mode 3
Screen Rotation
On
Off
Touch rectify
Test
Pan
Tilt
Focus
Colour
Gobo
Prism
Frost
Strobe
Advanced setup
Pan invert
On
Off
Tilt invert
On
Off
P/T rectify on
On
Off
Pan Offset
Tilt Offset
Lamp up when
Reset done
Power on
Manual
Factory setting
Sure
no
Statue setup
Work mode
Address
Version
Elapse
Total
DMX clr
Sys Rst
Function Mode
1. Set DMX Address
Click and select the "ADDR", you can enter the page of DMX address setting, range from 1 to 512,
the address code should not be greater than 512- channels quantity, otherwise the light will not
been controlled.
Enter the page of DMX address, click the blank area in right side of display.
Pop-up diglog will appear, as in Fig. 4. Modify value, then click ‘ENTER’ to confirm and save DMX
address code.