Brighter Smart 1000 - Operating Instructions; Installation

5
5. Operating Instructions
 The moving head is for spot effect for on-site decoration purpose.
 Don’t turn on the fixture if it’s been through severe temperature difference like after
transportation because it might damage the light due to the environment changes. So make
sure to operate the fixture until it is in normal temperature.
 This light should be keep away from strong shaking during any transportation or movement.
 Don’t pull up the light by only the head, or it might cause damages to the mechanical parts.
 Don’t expose the fixture in overheat, moisture or environment with too much dust when
installing it. And don’t lay any power cables on the floor. Or it might cause electronics shock
to the people.
 Make sure the installation place is in good safety condition before installing the fixture.
 Make sure to put the safety chain and check whether the screws are screwed properly when
installing the fixture.
 Make sure the lens are in good condition. It’s recommended to replace the units if there are
any damages or severe scratch.
 Make sure the fixture is operated by qualified personnel who know the fixture before using.
 Keep the original packages if any second shipments is needed.
 Don’t try to change the fixtures without any instruction by the manufacturer or the
appointed repairing agencies.
 It is not in warranty range if there are any malfunctions from not following the user manual
to operate or any illegal operation, like shock short circuit, electronic shock, lamp broke, etc.
6. Installation
The unit should be mounted via its screw holes on the bracket. Always ensure that the unit is firmly
fixed to avoid vibration and slipping while operating. And make sure that the structure to which you
are attaching the unit is secure and is able to support a weight of 10 times of the unit’s weight. Always
use a safety cable that can hold 12 times of the weight of the unit when installing the fixture.
The equipment must be fixed by professionals. And it must be fixed at the safe place where it is not
available for other people.
Rigging (Optional)
This equipment can be positioned and fixed by clamp in every direction of the stage. Locking
system makes it easy to fasten to the bracket.
Attention! Two clamps are needed to fix the equipment. Every clamp is locked by fastener of 1/4
kind. Fastener can only be locked clockwise.
Attention! Fasten a safety string to the additional hole of the side aluminium piece. The secondary
accessory cannot hang on the delivery handle. Nip the equipment on bracket.