BrightSign HD222, HD1022
17
All information provided in this reference manual applies to products under development. The characteristics and specifications of these products are subject to
change without notice. BrightSign assumes no obligation regarding future manufacturing unless otherwise agreed to in writing. © BrightSign LLC, 2015
MOUNTING PROCEDURE
The HD222 and HD1022 can be mounted on a wall using the brackets attached to each side. It is recommended that you
mount the device using four screws (one for each bracket slot). The screws should have a major diameter between
3.5mm and 4.2mm.
Important: Nails should not be used to mount the device.
To Previous Page
Loading...
