CruzinBrightz™
Instructions
©Copyright Brightz, Ltd. 2016
Patent Pending
All rights reserved
Step 1 - Install Batteries:
Remove/unscrew battery cover.
Remove battery holder. (Tilt unit downward and it will slide out)
Insert 3 fresh/new AA batteries into battery holder, observing the correct polarity (+/-).
Align Arrow on battery holder with arrow on light unit
Slide Battery Holder back into tube.
Replace battery cover by screwing back into place
On/Off Button is located on side of Lighting Unit
Important Battery Warnings:
Do not mix old and new batteries and do not mix alkaline, standard (carbon-zinc) or rechargeable (ni-cad, ni-mh,
etc.) batteries.
CAUTION: BATTERIES MAY EXPLODE OR LEAK, AND CAUSE BURN INJURY IF RECHARGED, DISPOSED OF IN FIRE,
MIXED WITH A DIFFERENT BATTERY TYPE, OR INSERTED BACKWARDS. REPLACE ALL USED BATTERIES AT THE SAME
TIME. CLEAN BATTERY CONTACTS AND CONTACTS ON THE DEVICE PRIOR TO INSTALLING. REMOVE BATTERIES IF
ITEM WILL NOT BE USED FOR LONG PERIODS OF TIME. WHEN BATTERY EXPIRES REMOVE PROMPTLY.
Step 2 - How to place CruzinBrightz™ on bicycle.
Select position on handlebars you want to place CruzinBrightz™.
Loosen screw on clamping device to open clamp. (Ensure that the light lens is pointed downward, to
illuminate pavement below the bicycle.)
Position clamp around handlebar.
Tighten screw.
To Next Page
Need help?
General
