Brightz Wheel Cardz User Manual

Wheel Cardz
™
by Brightz
Instructions
© Copyright Brightz, Ltd. 2019
Patent Pending • All rights reserved
Step 1 – Placement
Select a position on the bike where you want to place
Wheel Cardz™. See diagram for recommended
placement.
Loosen the screw on the clamp to open it. Position the
clamp around the bike frame so that the clip mouth is
facing the wheel spokes and tighten the screw.
Step 2 – Insert Card
Insert any card into the clip, making sure the card is secured in both sets of rubber teeth. Adjust the card
and clamp so that about 1/4" inch of the card is in between the spokes.
Rubber Teeth

Brightz Wheel Cardz Specifications

General

Power Source	Battery
Material	Plastic
Product Type	Bike Wheel Lights
Type	Spoke Lights
Color	Multicolor

Summary

Step 1: Product Placement

Positioning the Clamp

Loosen screw, position clamp around bike frame facing spokes, and tighten.

Step 2: Card Insertion

Securing the Card

Insert card into clip, ensure it's secured by rubber teeth, adjust for spoke clearance.

Step 3: Clip Separation (Optional)

Removing the Clip

Pull the tab outwards and slide to detach the clip from the clamp.

Reattaching the Clip

Slide the clip into place until the tab clicks to reattach it.

Important Safety Warnings

Usage Precautions

Do not operate while bike is moving; avoid mounting on moving parts. Use only on bicycles.