MATCH LIGHTING THE SIDE BURNER:
1. Open the lid to the side burner before lighting.
2. Turn the burner control knob to "OFF".
3. Strike and carefully place a match approximately 1/2" (1 to 2 cm) from the burner.
4. Turn the side burner control knob to the "HIGH" position. The burner should light within 5 seconds.
5. If the burner does not light, turn the control knob to "OFF" and wait 5 minutes for gas to dissipate and repeat
lighting procedure.
6. If the burner does not light within the first few attempts of match lighting, there is a problem with the gas supply.
Turn off the gas at the burner and cylinder. DO NOT attempt to operate the grill until the problem is found and
corrected. See "Trouble Shooting" section of this manual.
Note:
If burner does not light or flame is too low, you may have spider or other insect blockage in burner, or
the flow limiting device has been activated. See "Burner Assembly/Maintenance" under Proper Care
and Maintenance, or "Regulator Resetting Procedure" under Connecting LP Cylinder and
Hose/Regulator to Grill.
LIGHTING THE SEAR BURNER:
1. Open lid before lighting sear burner.
2. Make sure all control knobs are in the "OFF" position.
3. Push and hold down the SEAR BURNER control knob and turn SLOWLY
(2 to 3 seconds) to "HIGH". You should hear the igniter click.
Note: Step 3 may need to be repeated 2-3 times to light grill.
4. If ignition does NOT occur in 5 seconds, turn control knob to “OFF”,
wait 5 minutes to allow gas to dissipate and repeat lighting procedure.
5. If burner does not ignite using the igniter, wait 5 minutes, see
"Match Lighting the Sear Burner" section.
6. To turn off, turn control knob clockwise until it locks in the "OFF" position.
This does not turn off the gas flow from the cylinder.
MATCH LIGHTING THE SEAR BURNER:
1. Open the lid to the sear burner before lighting.
2. Make sure control knob is in the "OFF" positi on.
3. Strike and carefully place a match approximately 1/2" (1 to 2 cm) from the sear burner.
4. Push and turn the sear burner control knob to the "HIGH" position. The burner should light within 5 seconds.
5. If the burner does not light, turn the control knob to "OFF" and wait 5 minutes for gas to dissipate and repeat
lighting procedure.
6. If the burner does not light within the first few attempts of match lighting, there is a problem with the gas supply.
Turn off the gas at the burner and cylinder. DO NOT attempt to operate the sear burner until the problem is found
and corrected. See "Trouble Shooting" section of this manual.
Note: Observe flame height on main and side burners when
lit: Flame should be a Blue/Yellow color between
1"–2" when burner is on "HIGH."
TURNING OFF THE GRILL:
1. Turn off the cylinder valve.
2. Turn all burner control knobs to the "OFF" position.
Note: Turn off LP cylinder first to prevent gas
from being left in the system under pressure.
11
To turn off the cylinder valve,
turn knob clockwise until it stops.
CAUTION:
• The cylinder valve should always be in the off,
or closed, position when the grill is not in use.
To Next Page
Loading...
