32
REPLACING THE LED BATTERY
IN THE SEAR BURNER CONTROL KNOB
Switch
Battery Tab
Loosen screw to battery
tab using a screwdriver.
Rotate the battery tab to
gain access to the
battery pack.
Remove the old battery
pack from the sear
burner control knob.
Replace with a new
battery pack.
Reposition the
battery tab back to
its original position.
Secure the battery tab using a screwdriver.
Tighten securely. To test if working properly,
press the switch with fingertip.
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
A replacement battery pack may be purchased at Brinkmann Customer Service by calling 800-527-0717
NOTE: The battery pack can be replaced by using three (3) AG13 or LR44 battery cells.
or by visiting our website at
To Next Page
Loading...
