EasyManua.ls Logo

Brinkmann Nyquist - Safety Information; Legal Regulation; Operating Conditions; Power Supply Safety

Brinkmann Nyquist
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SAFETY INFORMATION
Legal regulaon of the European Community:
This D/A Converter had been designed and tested according to the guidelines EN55013 and EN55020,
and it meets the safety requirements EN60065.
Safety Informaon:
Brinkmann products should only be used in dry rooms with an ambient temperature between 55-86
degrees Fahrenheit (13-30 degrees Celsius) and are only designed for 220-240V / 110-120V, 50 and
60Hz alternang current.
Please verify that the voltage rang of your power supply corresponds to the voltage requirement
in your country!
Always keep the D/A Converter and power supply away from moisture, heat, open re and other
extreme condions. Never expose to direct sunlight.
Power Supply:
The power supply is only to be connected to grounded wall sockets.
Please connect or disconnect the power supply from the D/A Converter only when the mains plug is
disconnected from the mains.
Always disconnect the power supply from the mains when the D/A Converter is not used for a longer
period of me (during holidays etc. )
Never leave the power supply unaended while it is connected to the mains.
Never place containers with uids on either D/A Converter or power supply.
Never use solvent or sprays on any part of the D/A Converter or power supply!
There are NO user-serviceable parts inside the power supply.
The Mains Fuse is located externally, in the AC Receptacle Socket.
Never open the Chassis or Fuse Holder while the power supply is connected to the mains!
Aenon, dangerous voltage!
The power supply is equipped with a temperature limiter that switches o at about 150 degrees
F (65°C) ; to guarantee proper funcon please make sure to maintain free space for air circulaon
measuring 12” (30cm) above the power supply and 4” (10cm) on either side. The heatsinks and the
power supply must never be covered!
Aer disconnecng from the mains, the D/A Converter can be cleaned with a dry cloth or so brush.
Do NOT use liquid cleaners! Wet cleaning can cause damage!
Repairs, modicaons etc. are only to be carried out by Brinkmann Audio GmbH itself or by our
specically authorized service centers!
3