Brinkmann Nyquist - Connecting Nyquist; Output and Power Connectors; Digital Input Ports; Connection Sequence

Nyquist features RCA and XLR outputs, located on the right and le side of the main back panel and
a 7-pole socket for the connecon of the power supply.
The digital module features several dierent inputs on the small centre back panel:
Ethernet connector: Connect to your local network for Streaming
Toslink (opcal) S/PDIF input: Connect to a digital source with opcal output
USB input: Connect to PC/MAC or a server through a dedicated USB audio cable
Coax S/PDIF input (RCA): Connect a digital source with single-ended 75Ohm output
AES/EBU input (XLR): Connect a digital source with balanced 110Ohm output
Please keep to the following order when connecng Nyquist:
1. connect Signal Inputs from your digital sources to the appropriate Digital Inputs of Nyquist
2. connect the 7-pole plug of the power supply cable to the 7-pole connector on rear panel of Nyquist
and ghten the cap screw
3. connect RCA or XLR outputs from Nyquist to the respecve inputs of the preamplier or integra-
ted amplier
4. connect the power supply to the mains (do this as last step!)
Nyquist does not require external power condioning because its power supply incorporates a so-
phiscated power lter.
A dedicated connecon to the mains without interference is benecial for Nyquist. It is important
not to connect the D/A Converter to the same power distributor as, for example, power ampliers
with irregular power consumpon.
8