Brinly DTZ-48BH - Page 7

1009719 Rev E
ASSEMBLY
================================================================================================
Figure 5.
1/2” Nylon Lock Nut
Qty. 1
9
5/8” Hex Nut
Qty. 1
11
1/2” x 3-1/2” Hex Bolt
Qty. 1
5
5/8” x 4” Hex Bolt
Qty. 1
12
5/8” Acorn Nut
Qty. 1
10
5
12
11
9
10
2
6
Bolt tube with decal (6) to clamp arm (2) using hardware shown,
then install 5/8” x 4 hex bolt (12), 5/8” hex nut (11), and 5/8” acorn
nut (10). NOTE: Tighten the 5/8” x 4 hex bolt (12) into the acorn
nut (10) enough so flat side on the acorn nut (10) is flush with the
welded nut on the clamp arm (2).
Figure 4.
5/16” Washer
Qty. 4
26
5/16” Lock Washer
Qty. 4
27
5/16” Hex Nut
Qty. 4
28
5/16” x 1” Carrage Bolt
Qty. 4
24
24
28
26
27
19
21
Bolt frame brackets (19) to tray
(21) using hardware as shown