23 1018959-B
==================================================================================================
ASSEMBLY
Assembly Step 19
A. Select the proper tools to remove the leads to the battery terminals. Note: If you do not have insulated tools, use
electrical tape to wrap all exposed non-working surfaces of the tools. It is important to take these steps to reduce
the risk of causing an electrical spark.
Installing the Electrical Connections
C. Verify
that the
leads are
properly
attached:
and
Tractor RED LEAD is Attached to
the Positive (+) Battery Terminal
+
Tractor BLACK LEAD is Attached to
the Negative (-) Battery Terminal
-
Assembly Step 20-A
Attach the red lead (with the fuse)
of the Wire Harness Battery
Connector (38) and the red lead
from your engine to the positive (+)
battery terminal.
CAUTION: Avoid Injury!
Contact with exposed electrical wires can cause
sparks that could cause a battery to explode. Make
sure all wires connected to the positive terminal of the
battery are covered completely to prevent accidental
contact with tools or other metal objects.
CAUTION: Avoid Injury!
To help prevent electrical spark, install red wire
to the positive (+) battery terminal rst. Then
install black wire to negative (-) battery terminal.
To prevent damage to wiring, make sure hood
does not close on wires or connectors.
B. Put on gloves and eye protection.
CAUTION
: AVOID INJURY!
Care should be used when working around batteries. Use insulated tools
when making battery connections. Heavy gloves and eye protection
should be worn when making battery connections.
NOTE: Ensure the red battery boot slides back onto positive battery cable post.
Red
Lead
38
Connects to the positive (+) battery terminal
+
English Manual
To Next Page
Loading...