Bristan Bliss BL385 B

Questions and Answers

A
Ashley SimmonsAug 5, 2025
What to do if there is no water flow from my Bristan Bathroom Fixture?
- K
  Kathy HillAug 5, 2025
  If you're experiencing no water flow from your Bristan Bathroom Fixture, here's what you can check: * Ensure the water isolating valve is turned on. * Inspect and clean the filter if it's blocked by turning off the water supply first, then removing and cleaning the filter. * Check the outlet hose mesh filter for blockages; remove the outlet hose from the shower and clean the mesh filter. * Make sure the power supply to the unit is switched on.
G
Gregory CarterAug 9, 2025
Why is my Bristan Bathroom Fixture shower running hot and cold?
- N
  Nicholas MerrittAug 9, 2025
  If your Bristan Bathroom Fixture shower runs hot and cold, it might be due to the water pressure being at the minimum requirement. Check the running pressure (it should be a minimum of 0.7bar), and wait until the pressure increases.
J
Jennifer WalkerAug 14, 2025
What to do if my Bristan Bathroom Fixture water temperature is too hot?
- K
  kristophergarciaAug 14, 2025
  If the water temperature from your Bristan Bathroom Fixture is too hot, it could be due to insufficient water flowing through the shower. Try cleaning the handset. Increase the water flow by turning the temperature control knob to a cooler setting and reduce the power setting.
M
Michael GonzalezAug 18, 2025
Why does my Bristan Bathroom Fixture shower temperature cycle between hot and cold?
- J
  James HernandezAug 18, 2025
  The shower temperature may cycle between hot and cold because the shower temperature is set too high. This can cause the thermal cut out to turn off the heating elements to reduce the water temperature. To resolve this, turn the shower temperature control anti-clockwise to lower the water temperature.
B
Brian StephensAug 22, 2025
What to do if ‘LOW PRESSURE’ appears on my Bristan Bathroom Fixture?
- C
  Cheyenne MillerAug 22, 2025
  If ‘LOW PRESSURE’ is displayed on your Bristan Bathroom Fixture, it indicates a low-pressure water supply to the shower unit or low water flow through the shower handset. Turn off the unit and wait until the water pressure increases before using it again. You can also try increasing the water flow rate by turning the temperature control to a cooler setting.
C
Carolyn CraigAug 27, 2025
What does it mean when letters “CL” appear in the temperature indicator display of my Bristan Bathroom Fixture?
- N
  Nicholas Wilkinson DDSAug 27, 2025
  The letters “CL” appearing in the temperature indicator display of your Bristan Bathroom Fixture are a reminder to routinely service-clean the shower to maintain showering performance. This will show for five shower cycles. Perform the maintenance actions in the Maintenance Section, cleaning the Showerhead, Inlet Filter and Outlet Hose Mesh Filter.
M
morenomatthewAug 31, 2025
What does it mean when symbols “--” appear in the temperature indicator display of my Bristan Bathroom Fixture?
- T
  Tracy AdamsAug 31, 2025
  The symbols “--” appearing in the temperature indicator display indicates that the Bristan Bathroom Fixture unit is in Stand-By mode. The shower is powered and ready to start. The shower is ready to use.