Why does my Bristan Bathroom Fixtures temperature cycle between hot and cold?
If your Bristan Bathroom Fixtures shower temperature cycles between hot and cold, it might be set too high. Try turning the shower temperature control anti-clockwise to reduce the water temperature. This prevents the thermal cut-out from activating and disrupting the heating elements.
How to fix Bristan Cheer CHE85 W with no water flow?
If your Bristan Bathroom Fixtures shower has no water flow, here's what to check: * Ensure the water isolating valve is turned on. * Inspect the filter for blockages; if blocked, turn off the water supply and clean the filter. * Check the outlet hose mesh filter for blockages; if blocked, remove the outlet hose from the shower and clean the mesh filter. * Confirm that the power supply to the shower is switched on.
What to do if Bristan Bathroom Fixtures runs hot and cold during use?
If your Bristan Bathroom Fixtures shower runs hot and cold during use, it might be due to low water pressure. Check that the running pressure is at least 0.7 bar. Wait for the pressure to increase to stabilize the shower temperature.
General| Brand | Bristan |
|---|---|
| Model | Cheer CHE85 W |
| Category | Bathroom Fixtures |
| Language | English |
Switch off power, isolate circuit, use double pole switch per regulations.
Mount on finished wall, avoid tiling edges, use correct shower heads.
Do not install or use the shower in freezing conditions.
Minimum pressure, maximum static pressure, and spill-over level requirements.
Control for selecting power settings: Cold, Medium (eco), and High.
Adjustable control for shower temperature, including a safety device.
Inlet/outlet connections, water entry points, operating pressures, and supply requirements.
Specifies available entry points for electrical cables.
Electrical installation must comply with IEE Wiring and Building Regulations.
Requirement for RCD, MCB/Fuse, and ensuring adequate supply/earth rating.
Use a 45 Amp double pole switch and secure cable routing per IEE.
Outlet discharge above spill-over, 20mm vertical distance, backflow prevention.
Mains water connection, minimum pressure, flow rate, and maximum static pressure.
Mount on a flat, waterproof surface, not tiled up to edges.
Use appropriate fixings for partition or friable substrate walls.
Diagrams showing different inlet connection possibilities and how to change them.
Fit a stop valve and flush pipes before connecting.
Fitting hole covers and explanation of the Pressure Relief Device (PRD).
Ensure earth continuity and route cables per IEE regulations.
Connect earth, neutral, and live cables to terminals, ensuring tight connections.
Diagrams showing various electrical cable entry points.
Steps for fitting the riser rail, including slider, hose retainer, and brackets.
How to fit the hose and handset into the slider.
Flush the system to remove debris and ensure water flow before heating.
Set temperature knob to minimum flow and then adjust for continuous flow.
Instructions on how to start and stop the shower using the control knobs.
Adjust temperature gradually and test water before use.
Clean unit with soft cloth, avoid abrasives.
Instructions for cleaning the showerhead, inlet filter, and outlet hose mesh filter.
Register guarantee within ten days and ensure installation per manual.
Policy regarding service calls, replacement parts, and contact information.
To Next Page
