Bristan W BATH02 C - Introduction; Installation Procedure

Introduction
Thank you for choosing Bristan, the UK’s leading taps and showers expert. We have designed this
product with your enjoyment in mind. To ensure that it works to its full potential, it needs to be
fitted correctly. These fitting instructions have been created to give you all of the information you
need and, if you need any further help, please do not hesitate to give us a call on 0330 026 6273.
Installation
1. Identify all components
are present prior to
installation.
2. Fit the waste body (1) to
the underside of the
bath using the rubber
washer (2).
3. Fit the waste plate (3) to
the bath using the foam
washer (4) as shown in
the diagram. Secure
using the screw (5).
4. Fit the overflow elbow
(6) to the sink using the
overflow washer (7).
5. Screw the overflow face
(8) onto the thread of
the overflow elbow (6).
6. Connect the overflow
tube (9) to the waste
body (1) and overflow
elbow (6).
7. Check all joints and
connections for leaks.
8. See over the page for
aftercare instructions
.
1
5
3
9
8
6
7
4
2