Date of Issue: 01/2016
Document No.: LSA-AOI-2-1-0-CL
3.1 Introduction
Section 3 provides checklists and amplified procedures for coping with
various emergencies that may occur. Emergencies caused by aircraft or
engine malfunction are extremely rare if proper pre-flight inspections and
maintenance are practiced.
However, should an emergency arise, the basic guidelines described in this
section should be considered and applied as necessary to correct the
problem.
3.2 Engine Failure
Engine failure during take-off run
1. Throttle - reduce to idle
2. Ignition - switch off
3. Apply brakes
Engine failure during take-off
1. Speed - gliding at 120 km/h (65 KIAS)
2. Altitude - below 150 ft: land in take-off direction
- over 150 ft: choose a landing area
3. Wind - find direction and velocity
4. Landing area - choose free area without obstacles
5. Flaps - extend as needed
6. Fuel Selector - shut off
7. Ignition - switch off
8. Safety harness - tighten
9. Master switch - switch off before landing
10. Land
To Next Page
