Brivis SP435UN - SP4 Model Guidelines; SP4 Internal Installation

500mm
• From an electricity meter or fuse box (prohibited area extends to ground level).
1000mm
• Measured vertically, from an opening window, door, non-mechanical air inlet or any other opening into the
building (except sub floor ventilation).
• From a gas meter.
• From a mechanical air inlet, including a spa blower, measured both vertically and horizontally.
• A flue terminal of this type shall not be located under a roofed area, unless the roofed area is fully open on at
least two sides, and a free flow of air at the appliance is achieved.
4. SP4 Model Guidelines
4.1 Heater Dimensions
SP4 Universal
Diagram 11.
A
B
C
D
E
F
G
H
I
J
K
øSa
øRa
HEATER END PANEL
GAS INLET
FLUE INLET
LOOM MAINS
Dimension [mm] A B C D E F G H I J K øSa øRa
SP415UN 625 845 397 14 467 197 447 197 235 95 495 300 300
SP421UN 625 845 397 14 467 197 447 197 235 95 495 300 300
SP430UN 644 923 549 14 487 197 487 237 235 250 515 350 350
SP435UN 644 923 549 14 487 197 487 237 235 250 515 400 400
Note: SP4 Universal is approved for internal or external applications.
4.2 Internal Installation
Diagram 12. Duct Connection Options
Preferred
Option
Preferred
Option
Preferred
Option
Preferred
Option
SP415UN & SP421UN
SP430UN & SP435UN
Plan view Plan view
Preferred
Option
Preferred
Option
Preferred
Option
Preferred
Option
SP415UN & SP421UN
SP430UN & SP435UN
Plan view Plan view
10
324702 CAAB024953 StarPro Installers Heat issue D.indd 13 17/05/16 8:41 AM