EasyManua.ls Logo

Broan Losone Select Series - User Manual

Broan Losone Select Series
8 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
LOSONE SELECT
®
L400 SERIES • L500 SERIES • L700 SERIES
®
Page 1
LOSONE SELECT
®
VENTILATORS
Ceiling/Wall Mount
READ AND SAVE THESE INSTRUCTIONS
TABLE OF CONTENTS
This manual is divided into sections as follows:
“WARRANTY”
“TYPICAL INSTALLATION”
This section shows a common installation in new and existing,
frame construction.
- Mounting (new construction)
- Mounting (existing construction)
- Wiring
- Ducting (horizontal blower discharge)
“MOUNTING OPTIONS”
“WIRING OPTIONS”
-Wiring Plate Position
“DUCTING OPTIONS”
- Blower Discharge Positions
- Ducting (vertical blower discharge)
“USE AND CARE”
“SERVICE PARTS”
Page 1
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR IN-
JURY TO PERSONS, OBSERVE THE FOLLOWING:
1. Use this unit only in the manner intended by the manufacturer. If
you have questions, contact the manufacturer at the address or
telephone number listed in the warranty.
2. Before servicing or cleaning unit, switch power off at service panel
and lock the service disconnecting means to prevent power from
being switched on accidentally. When the service disconnecting
means cannot be locked, securely fasten a prominent warning
device, such as a tag, to the service panel.
3. Installation work and electrical wiring must be done by a quali-
fied person(s) in accordance with all applicable codes and stan-
dards, including fire-rated construction codes and standards.
4. Sufficient air is needed for proper combustion and exhausting of
gases through the flue (chimney) of fuel burning equipment to
prevent backdrafting. Follow the heating equipment
manufacturer’s guideline and safety standards such as those
published by the National Fire Protection Association (NFPA),
and the American Society for Heating, Refrigeration and Air Con-
ditioning Engineers (ASHRAE), and the local code authorities.
5. When cutting or drilling into wall or ceiling, do not damage elec-
trical wiring and other hidden utilities.
6. Ducted fans must always be vented to the outdoors.
7. To reduce the risk of fire, use only metal ductwork.
8. If this unit is to be installed over a tub or shower, it must be
marked as appropriate for the application and be connected to a
GFCI (Ground Fault Interrupter) - protected branch circuit.
9. Never place a switch where it can be reached from a tub or
shower.
10. This unit must be grounded.
CAUTION
1. For general ventilating use only. Do not use to exhaust hazard-
ous or explosive materials and vapors.
2. To avoid motor bearing damage and noisy and/or unbalanced
impellers, keep drywall spray, construction dust, etc. off power
unit.
3. Please read specification label on product for further informa-
tion and requirements.
Installer: Leave this manual with
the homeowner.
Homeowner: Use and Care
information on page 3.
!
WARRANTY
BROAN-NUTONE CANADA ONE YEAR LIMITED WARRANTY
Broan-NuTone Canada warrants to the original consumer purchaser of its products
that such products will be free from defects in materials and workmanship for
a period of one year from the date of original purchase. THERE ARE NO
OTHER WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING, BUT NOT
LIMITED TO, IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS
FOR A PARTICULAR PURPOSE.
During this one-year period, Broan-NuTone Canada will, at its option, repair
or replace, without charge, any product or part which is found to be defective
under normal use and service.
THIS WARRANTY DOES NOT EXTEND TO FLUORESCENT LAMP STARTERS
AND TUBES. This warranty does not cover (a) normal maintenance and service
or (b) any products or parts which have been subject to misuse, negligence,
accident, improper maintenance or repair (other than by Broan-NuTone Canada),
faulty installation or installation contrary to recommended installation instructions.
The duration of any implied warranty is limited to the one-year period as
specified for the express warranty.
BROAN- NUTONE CANADA’S OBLIGATION TO REPAIR OR REPLACE, AT
BROAN-NUTONE CANADA’S OPTION, SHALL BE THE PURCHASER'S SOLE
AND EXCLUSIVE REMEDY UNDER THIS WARRANTY. BROAN-NUTONE
CANADA SHALL NOT BE LIABLE FOR INCIDENTAL, CONSEQUENTIAL OR
SPECIAL DAMAGES ARISING OUT OF OR IN CONNECTION WITH PRODUCT
USE OR PERFORMANCE. Some jurisdictions do not allow the exclusion or
limitation of incidental or consequential damages, so the above limitation or
exclusion may not apply to you.
This warranty gives you specific legal rights, and you may also have other
rights, which vary by jurisdiction. This warranty supersedes all prior warranties.
To qualify for warranty service, you must (a) notify Broan-NuTone Canada at
the address or telephone number below, (b) give the model number and part
identification and (c) describe the nature of any defect in the product or part. At
the time of requesting warranty service, you must present evidence of the
original purchase date.
Broan-NuTone Canada Inc.
1140 Tristar Drive, Mississauga, Ontario L5T 1H9 (1-888-882-7626)
99042811A
Question and Answer IconNeed help?

Do you have a question about the Broan Losone Select Series and is the answer not in the manual?

Summary

Warranty Information

Typical Installation Guide

Mounting in New Frame Construction

Details the process of mounting the ventilator in new frame construction.

Mounting in Existing Frame Construction

Details the process of mounting the ventilator in existing frame construction.

Wiring Connections

Explains the electrical wiring connections required for the unit.

Horizontal Blower Discharge Ducting

Illustrates ducting configurations for horizontal blower discharge.

Mounting Options and Configurations

Factory-Shipped Mounting Bracket Position

Shows mounting brackets in their original factory position for installation.

Flipped Mounting Brackets for Outlet Side

Illustrates mounting brackets flipped for mounting to the outlet sides of housing.

Brackets Mounted Perpendicular to Outlet

Shows mounting brackets attached perpendicular to the housing outlet.

Flipped Brackets for Increased Clearance

Illustrates flipped mounting brackets for additional clearance.

Brackets Mounted to Top of Housing Sides

Shows mounting brackets attached to the top sides of the housing.

Ducting Options

Blower Discharge Positions

Details different blower and duct connector positions for discharge.

Vertical Blower Discharge Ducting

Illustrates ductwork connection for vertical blower discharge.

Wiring Options

Wiring Plate Position

Shows how the wiring plate mounts to the housing for cable connections.

Use and Care Instructions

Service Parts Identification

Broan Losone Select Series Specifications

General IconGeneral
Voltage120 V
Housing MaterialGalvanized Steel
Blade MaterialPlastic
TypeCeiling
Mounting TypeCeiling
Duct Size4 in

Related product manuals