Broan QP236BL - Prepare Hood Location; Measure the Installation

BR N
QP2 SERIES
PREPARE HOOD LOCATION
Page 4
MEASURE THE INSTALLATION
El Use the for of ductwork
diagram below, placement
proper
and electrical cutout in cabinet or wall. For a non-ducted
installation, DO NOT cut a duct access hole.
31,4"X 10"
HOOD MOUNTING SCREWS (5) VERTICAL DUCTING
8"(30" hood) 115/8"(30" hood)
hood) _ _ 145/8"(36" hood) --,,
hood) 175/s'' (42" hood)
CABINET FRONT
CABINET _ _=
BOTTOM E _ 67/8" _ ;| I I |
I*---81/,"--_- 81/,'_ I I ill [
- " -- 1 10/8"
, VERT,CA O--- --qli"I2'8"'111' '
I ACCESSH°L--._LL.-J
t t ELECT'RICAL
WOOD SHIMS CENTER ACCESS HOLE
recessed-bottom
LINE (in cabinet bottom)
cabinets only)
31A"X 10"
WOOD SHIMS
(recessed-bottom HORIZONTAL DUCTING
cabinets only)
CABINET FRONT 13/8"
--/:
I HORIZONTAL DUCT
CABINET! ACCESSHCLE =
BOTTOM1__24
b'_ 67/8"
I 115/8"(30"hood) I 115/8"(30"hood)
_- 14 5/8"(36" hood) --_'= 145/8"(36"
| 17 5/8"(42" hood) I 175/8"(42" hood)
HOOD
ELECTRICAL
MOUNTING CENTER ACCESS HOLE
SCREWS (5) LINE (in wall)
HOOD MOUNTING SCREWS (5)
11 5/8"(30" hood) 11 5/8"(30" hood)
14 5/8"
17 5/8" (42" hood)
l 7-IN. ROUND
DUCTING
l
107/8"
WOOD SHIMS t ELECTRICAL
(recessed-bottom CENTER ACCESS HOLE
cabinets only) LINE (in cabinet bottom)
Note the extra wood shim and mounting screw near the
cabinet front, on the cabinet center line.
ROOF CAP 3%" X 10" or
7" ROUND DUCT
(For vertical
SOFFIT
HOUSE WIRING
or Back of hood)
t
24" - 30" ABOVE
COOKING SURFACE
3%" X 10" DUCT
(For horizontal discharge)
El
The minimum hood distance above cooking surface
MUST NOT BE LESS than 24" (to top of hood).
A maximum of 30" above cooking surface is highly
recommended for best capture of cooking impurities.
Distances over 30" are at the installer's and user's
discretion; providing that the cabinet height permits.
CONTENTS
INCLUDED WITH THE HOOD:
_# % (1)314"xlo"
DAMPER / DUCT
CONNECTOR
SE
FILTERS
(2- FOR 30"& 36" HOODS)
3- FOR 42" HOODS)
(1) 7" ROU
(4) (_ DUCT
HALOGEN "_M CONNECTOR
BULBS
(1) PARTS BAG CONTAINING:
WIRE (1)
NUTS BULB
SUCTION
CUP TOOL
(9) @
#8 X 1/4"
DUCT
CONNECTOR
SCREWS
(5)
#10 X 5/8"
RD. HD.
MOUNTING
SCREWS
(1)
NON-DUCT
DIVERTER
(2)
#8 X 5/16"
MACHINE
SCREWS
@
(2)
#8 WASHERS
FOR NON-DUCT
DIVERTER